V-Belt - Yamaha FX Nytro FX10Y Owner's Manual

Bleeding the cooling system
The cooling system must be bled if the cool-
ant reservoir becomes empty, if air can be
seen in the cooling system, or if there is a
cooling system leak. Consult a Yamaha deal-
er.
ECS00500
NOTICE
Operating the engine with an improperly
bled cooling system can cause overheat-
ing and severe engine damage.
Replenishing the coolant
1. Remove the shroud. (See page 44 for re-
moval procedures.)
2. Remove the coolant reservoir cap and
add coolant until it reaches the "FULL"
mark.
1. Coolant reservoir cap
Periodic maintenance and adjustment
1. "FULL" mark
Recommended antifreeze:
High-quality ethylene glycol antifreeze
containing corrosion inhibitors
Antifreeze and water mixing ratio:
3:2
Total amount:
FX10 3.40 L (3.59 US qt, 2.99 Imp.qt)
FX10MTR 4.70 L (4.97 US qt,
4.14 Imp.qt)
FX10RTR 3.40 L (3.59 US qt,
2.99 Imp.qt)
3. Start the engine and add coolant until the
coolant level stabilizes, and then stop the
engine.
4. Fill the coolant reservoir with coolant until
it reaches the "FULL" mark.
5. Install the coolant reservoir cap.
6. Check for any coolant leakage.
7. Install the shroud.
TIP
If you find any leaks, consult a Yamaha deal-
er.
ESU12064

V-belt

EWS00401
WARNING
Coming in contact with the rotating V-
G
belt or clutch parts can cause severe in-
jury or death. Never run the engine with
the drive guard removed.
55