Promise Technology ultratrak SX4000 User Manual page 86

UltraTrak SX4000, SX8000 & RM8000 User Manual
Q. Why can't I see the drives on the UltraTrak under FDISK?
A. If you have not created an array, the physical drive(s) attached to the
UltraTrak card will not be recognized by the operating system. The UltraTrak
controller is dedicated to RAID array management and does not provide any
means of addressing individual hard drives through the int 13h interface
used by FDISK. In order to access drives on the UltraTrak from MSDOS at
all, you must first create a RAID array.
Q. Why can't I see the array I just created in the Windows NT/2000/XP
Disk Administrator?
A. Since Windows NT/2000/XP does not yet support any method of
dynamically adding and/or removing logical devices to/from the system, you
must restart Windows. The next boot will show the new array under Disk
Administrator.
80