IBM eServer 220 xSeries Installation Manual page 44

12. If you have other options to install or remove, do so now; otherwise, replace the
13. Replace the cover (see "Installing the cover" on page 31 for details).
14. Reconnect the external cables and power cords; then, turn on the server.
30
IBM® xSeries 220: Installation Guide
(2) If you installed the microprocessor in connector U12, press down on the
latches on either side of connector J42, and install the VRM in connector
J42.
Note: If your server is a hot-swap model, reinstall the VRM in connector J42
after you reinstall the support bracket assembly.
b. Make sure that the VRM is oriented and aligned correctly.
c. Press the VRM into the connector.
Note: If you remove the microprocessor later, remember to install the
terminator card in the appropriate microprocessor connector and to
remove the VRM from the appropriate VRM connector. Refer to the
User's Reference on the IBM xSeries Documentation CD for details.
support bracket assembly.