IBM eServer 220 xSeries Installation Manual page 25

To remove the support bracket assembly, do the following:
1. Review the safety precautions in "Safety" on page v.
2. Turn off the server and peripheral devices and disconnect all external cables and
power cords.
3. Remove the cover (see "Removing the side cover" on page 10 for details).
4. If your server is a non-hot-swap model, continue with step 6.
5. If your server is a hot-swap model, press down on the latches on either side of
connector J42, and remove the voltage regulator module (VRM) from connector
J42. (See "System board option connectors" on page 4 for connector locations.)
Note: Remember to reinstall this VRM after you reinstall the support bracket
assembly.
6. Disconnect the fan cable (connector J10) from the system board. (See "System
board internal cable connectors" on page 5 for connector locations.)
Note: Remember to reconnect this cable after you reinstall the support bracket
assembly.
7. Carefully pull up on the end of the support bracket assembly that is closer to the
rear of the server; then, rotate and lift the support bracket assembly out of the
server.
8. Store the support bracket assembly in a safe place.
Chapter 2. Installing options
11