Raymarine RC435 Owner's Handbook Manual page 44

34
2. Use trackpad left/right to highlight SYSTEM SET UP and press ENTER
to display the System Set Up menu:
BEARING MODE
KEY BEEP
DISTANCE UNITS
SPEED UNITS
DEPTH UNITS
VARIATION
VARIATION MODE
DATE FORMAT
TIME OFFSET
LANGUAGE
SIMULATOR
SIMULATED SOG
SIMULATED COG
Figure 4-1: System Set Up Menu
3. Use trackpad up/down to move the highlight up or down the list.
4. When the desired parameter is highlighted, use trackpad left/right to
step through the settings.
5. When the desired values have been chosen, press ENTER to imple-
ment the change and return to the set up function bar.
Note: Settings are not saved until the ENTER key is pressed.
6. Press CLEAR to clear the function bar and return to normal operation.
Note: To return all settings to their original factory settings, perform a
factory reset as described in Chapter 6.
The table below lists the System menus and their options, shows the
factory default settings and provides space to make a note of personal
settings. Each parameter is described in the following subsections.
SYSTEM SET UP
TRUE
ON
nm
KNOTS
FEET
5°W
AUTO
MM/DD/YY
UTC
ENGLISH
OFF
5.0 KTS
340°T
RC435 and RC435i Chartplotters
D6247-3