Connect The Camera To The Network - Bosch MIC-71xx Installation Manual

20 en | Make Connections - Power and Control
10.5

Connect the Camera to the Network

Note: Refer to the following figure for an illustration of both options.
Option A:
1. Connect an Ethernet cable (Cat5e/Cat6) from the RJ45 connector of the camera to a
network switch attached to the Local Area Network (LAN).
2. Connect the dedicated network switch to the RJ45 connector on the computer.
3. Connect the 24 VAC wires to the power source.
4. Connect the RS-485 wires to the MIC-ALM-WAS-24 (optional).
5. Attach the green ground wire (item 3 in the figure above) from the camera to an earth-
ground connection on the mounting surface using the supplied screw or a suitable user-
supplied fastener.
Option B:
1. Connect an Ethernet crossover cable from the RJ45 connector of the camera directly to a
networking device such as a computer, a DVR/NVR, etc.
2. Attach the green ground wire (item 3 in the figure above) from the camera to an earth-
ground connection on the mounting surface using the supplied screw or a suitable user-
supplied fastener.
Figure 10.2: MIC7000 IP System Configuration
2015.12 | 3.0 | F.01U.291.520
A
2
1
B
1
2
1 MIC7000 camera
2 IP connection
3 Network switch
4 Networking device (computer, DVR/NVR, etc.)
2
3
4
4
Installation Manual
MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
Bosch Security Systems