Connect The Camera To The Network - Bosch MIC-7502-Z30B Installation Manual

MIC IP starlight 7000i
1 RJ45 (Cat5e/Cat6e) connector (male) (supporting High PoE) for power and
communication between a Bosch model of High PoE Midspan or a VJC-7000-90
2 24 VAC power wires (24 gage) to VG4-A-PSU1 or VG4-A-PSU2 (if not using a PoE
network)
3 Chassis (Earth) ground wire (18 gage) with connector lug
4 RS-485 connections for communication to / from the MIC-ALM-WAS-24
5 Liquid-tight cordgrip in the base of the camera
6 RJ45 coupler (female to female)
* For more information, refer to the installation manual Power Supply Units (AUTODOME VG5-
and MIC IP Camera Models) (shipped with VG4-A-PSU1 and VG4-A-PSU2).
Note: If the MIC camera will be installed directly to a mounting surface, instead of onto a MIC
DCA or a MIC wall mount bracket, Bosch recommends using the connector kit for your model
of camera to protect the connections against moisture and dust particles. Each kit provides
components for connecting as many as 5 MIC cameras.
MIC-IP67-5PK MIC7000 IP67 Connector Kit
Note: The PoE connection is not intended to be connected to exposed (outside plant)
networks.
8.5

Connect the Camera to the Network

Note: The total length of Cat5e/Cat6e cable must be less than 100 m (328 ft) between the
camera and the head-end system.
1. Make the appropriate network connections depending on the power source of your IP
network:
–
–
–
2. If applicable, connect the 24 VAC wires to the power source.
3. If applicable, connect the RS-485 wires to the MIC-ALM-WAS-24 (optional).
4. Attach the green ground wire (item 1 in the figure above) from the camera to an earth-
ground connection on the mounting surface using the supplied screw or a suitable user-
supplied fastener.
Bosch Security Systems
Description
If using a High PoE midspan power source:
a. Connect one end of a standard Ethernet cable (Cat5e/Cat6e Shielded Twisted Pair
(STP)) to the RJ45 connector of the camera.
b. Connect the other end of the Ethernet cable to the DATA + POWER OUT port on the
midspan. Note: You must ground cable at both ends!
c. Connect a standard Ethernet cable from the DATA port of the midspan device to the
Local Area Network (LAN).
If not using High PoE: Connect a standard Ethernet cable from the RJ45 connector of the
camera to the Local Area Network (LAN).
If not using PoE and if connecting directly to a computer, DVR/NVR, or other related
network device: Connect either a standard Ethernet cable or a crossover Ethernet cable
between the RJ45 connector of the camera and the network device. Note: You must
ground cable at both ends!
Installation Manual
Connections | en 29
Wire Color
Line (L) = Black
Neutral (N) = White
Green
+ = Purple
- = Yellow
GND = Brown
2017.09 | 0.12 | F.01U.xxx.xxx