Using Bradmin Professional Utility And The Ipx/Spx Protocol To Set The Ip Address - Brother NC-9100h Network User's Manual

The BRAdmin Professional utility can use the IPX/SPX or TCP/IP
protocols to communicate with the Brother Print/Fax server.
If you wish to use the TCP/IP protocol to manage the Print/Fax server
make sure that the print server has a valid IP address. If you are not
using DHCP, BOOTP or RARP, you will want to change the IP
address.There are two ways to change the IP address using the
BRAdmin Professional utility:
■
Use the IPX/SPX protocol.
■
Use the TCP/IP protocol and let BRAdmin Professional utility find
the Brother print server as an unconfigured device.
Using BRAdmin Professional utility and the IPX/
SPX Protocol to set the IP address
If your PC is using the Novell Netware Client software and is using
the IPX/SPX protocol, do the following:
1
Select IPX/SPX filter in the left frame of the main window.
2
Check the Print/Fax server name (the default node name is
BRN_xxxxxx , where xxxxxx is the last six digits of the
Ethernet address (MAC address)).
If you cannot find your server name, select the Device menu and
choose Search Active Devices (you can also press the F4 key) and
try again.
You can find the node name and MAC address by printing
out the printer configuration page. Refer to the User's Guide
Chapter 23 for information on how to print the configuration
page on your Print/Fax server.
3
Select the Print/Fax server that you wish to configure and
double click it. You will be asked for a password. The default
password is access .
4
Select the TCP/IP tab and set the IP address, Subnet mask
and Gateway as needed.
11 - 3 TCP/IP CONFIGURATION