Windows ® 2000 Printer Setup - Brother NC-9100h Network User's Manual

3
Select DLC Protocol and then OK or Add if using Windows
2000. You may be asked for the location of the files. For Intel
based computers, the necessary files are stored in the i386
directory of the Windows
platform, specify the correct directory on your Windows
CD-ROM. Click Continue (for NT 3.5x systems) or Close (for
NT 4.0 systems).
4
Reboot your system to make the change take effect. Windows
2000 should not require a re-boot.
®
Windows 2000 Printer Setup
1
Log into Windows
the Start menu, select Settings and then Printers.
2
Select Add Printer (If you have already installed a Brother
printer driver, double click the printer driver that you wish to
configure and then select Printers/Properties, select the Ports
tab, click on Add Port and continue from Step 6 (ignoring
steps 11-14 about installing the correct driver)).
3
Click Next.
4
Select Local Printer and make sure that Automatically detect
and install my Plug and Play printer is not checked.
5
Click Next.
6
Select the Create a new port: option and highlight Hewlett-
Packard Network Port.
7
Click Next.
8
A list of available Print/Fax server MAC addresses (Ethernet
addresses) appears in the larger box under Card Address.
Select the address of the desired Printer/Fax server (you can
see the Ethernet address on the Printer/Fax configuration page).
You can find the node name and MAC address by printing
out the printer configuration page. Refer to the User's Guide
Chapter 23 for information on how to print the configuration
page on your print server.
8 - 2 DLC PRINTING
®
NT CD-ROM. If you have a non-Intel
®
2000 with administrative privileges. From
®
®
NT
®