IBM eServer xSeries 300 User Reference Manual page 82

POST message
00180600 A PCI-to-PCI bridge error occurred. More than one PCI bus tried to access memory below
1 MB.
Action: Remove the PCI adapter that has the PCI bridge. If you can start the server without
If you cannot isolate and correct the problem, call for service.
00180700 xxxxyyyy Planar PCI device does not respond or disabled by user. (Where xxxx is the PCI
vendor ID and yyyy is the PCI device ID.)
Action: Start the Configuration/Setup Utility program, select Devices and I/O Ports, and make
00180800 An unsupported PCI device is installed.
Action: Remove the PCI adapters. If you can start the server without the adapters, reinstall
If the problem remains, call for service.
00181000 PCI error.
Action: Remove the PCI adapters. If you can start the server without the adapters, reinstall
If the problem remains, call for service.
01295085 The ECC checking hardware test failed.
Action: Call for service.
01298001 No update data is available for processor 1.
Action: Update the system BIOS to a level that supports the microprocessors installed in the
01298002 No update data is available for processor 2.
Action: Update the system BIOS to a level that supports the microprocessors installed in the
01298101 The update data for processor 1 is incorrect.
Action: Update the system BIOS to a level that supports the microprocessors installed in the
01298102 The update data for processor 2 is incorrect.
Action: Update the system BIOS to a level that supports the microprocessors installed in the
01298200 Microprocessor speed mismatch
Action: The microprocessors installed do not run at the same speed; install microprocessors
I9990301 A hard disk drive error occurred.
Action: Call for service.
I9990305 POST could not find an operating system.
Action: Install an operating system. If you have already installed the operating system, check
If you cannot reinstall the operating system, call for service.
Table 9. POST error messages.
68
xSeries 300: User's Reference
the adapter, reinstall and retest the adapter. If the adapter fails, replace it.
sure that the device is enabled. If the problem remains, call for service.
each adapter one at a time and retest after each is reinstalled. When an adapter fails,
replace it.
each adapter one at a time and retest after each is reinstalled. When an adapter fails,
replace it.
server.
server.
server.
server.
with identical speeds.
the drive startup sequence. If the drive sequence is correct, run the diagnostic tests to
verify that the hard disk drive is functioning correctly. If there is a problem with the hard
disk drive (such as a bad sector), you might need to reinstall the operating system.
Description