Table of Contents
Advertisement
Select Measurement Units
To select between standard units (mph, ºF, etc.)
or metric units (kph, ºC, etc.):
1. Press the "▲" or "▼" buttons until
"SET UNITS?" is displayed on the
Selectable Category part of the
display unit.
2. Press the "
" button to set the unit
preference.
3. Press the "▲" or "▼" buttons to select
"STAND" for standard or "METRIC" for
metric units.
4. Press the "
" button to confirm your
selection.
5. Next, you will see "WIND MPH". Press the
"▲" or "▼" buttons to select MPH, KPH,
or KNOTS for wind speed units.
6. Press the "
" button to confirm your
selection.
Units are now set.
Set Language
To select between English (default) or Spanish for the display unit language:
1. Press the "▲" or "▼" buttons until "SET LANG?" is displayed on the
Selectable Category part of the display unit.
2. Press the "
" button to set the language preference.
3. Press the "▲" or "▼" buttonss to select the desired language.
4. Press the "
" button to confirm your selection.
Language is now set.
Note: Display unit reverts to English language when display unit runs out of
power or is reset.
10
Troubleshooting
Problem
• Relocate the display unit and/or the 5-in-1 sensor.
The units must be within 330ft (100m) of each
other.
• Make sure both units are placed at least 3 feet
(.9m) away from electronics that may interfere
with the wireless communication (such as TVs,
microwaves, computers, etc).
• Use standard alkaline batteries (or lithium
No outdoor sensor
batteries in sensor when temperature is below
reception
-4ºF/-20ºC). Do not use heavy duty or
rechargeable batteries. NOTE: It may take up to
no bars
20 minutes for display unit and sensor to
synchronize after batteries are replaced.
• Synchronize the units:
1. Bring both the sensor and display unit indoors
and remove at least one battery from each.
2. Reinstall the battery in the outdoor sensor.
3. Reinstall battery into the display unit.
4. Let the units sit within a couple feet of each other
for about 20 minutes to gain a strong connection.
Flashing of the outdoor temperature may be an
Outdoor
indication of wireless interference.
temperature
• Make sure the A-B-C switch in the battery
compartments of both the display unit and sensor
is flashing or
are switched to the same letter. You may choose
showing dashes
A, B or C; but both units must match to sync up.
Sometimes changing to a different channel can help.
Weather Ticker
• Slow down the speed of the ticker (see page 16)
Hard to Read
• Weather Forecast icon predicts conditions for the
next 12 to 24 hours, not current conditions.
• Has Learning Mode icon disappeared from the
display unit? Learning Mode must complete
before forecast and pressure will be accurate.
Inaccurate forecast
• Allow unit to run continuously for 33 days.
Battery removal or resetting the display unit will
restart Learning Mode. After 14 days, forecast
should be fairly accurate, however Learning
Mode calibrates for a total of 33 days.
Possible Solution
19
Advertisement
Table of Contents
