Table of Contents
Advertisement
Troubleshooting
Problem
• Make sure both the display unit and 5-in-1 sensor
are placed out of direct sunlight and away from
any heat sources or vents (see page 11).
Inaccurate
• Make sure both units are positioned away from
temperature or
moisture sources (see page 11).
humidity
• Make sure 5-in-1 sensor is mounted at least 5ft off
of the ground.
• Calibrate indoor and outdoor temperature and
humidity (see page 22).
• Check to ensure the rain gauge stabilizer (plastic
tab) has been removed from the bottom of the
sensor (see page 7).
No rainfall
• Clear debris, such as leaves, out of the rain
collector funnel and debris screen.
• Calibrate the Rain Gauge (see page 23).
• What is wind reading being compared to? Pro
weather stations are typically mounted at 30ft
high or more. Make sure to compare data using
a sensor positioned at the same mounting height
and within the same general vicinity.
Inaccurate wind
• Check location of the sensor. Ensure itʼs
readings
mounted a minimum of 5ft in the air with no
obstructions around it (within several feet).
•Ensure wind cups are spinning freely. If they
hesitate or stop try lubricating with graphite
powder or spray lubricant.
• Ensure USB cable is securely connected to the
USB connectivity
display unit AND to PC USB port.
not working
• Confirm that the correct mode is selected (see
page 13).
• Check that the batteries are installed correctly.
Batteries may need to be replaced.
• Check that power adaptor is fully plugged in (if
Display screen
using power adapter for power source).
not working
• Reset the display by pressing the reset button,
located on the back of the display unit. Date and
time will need to be entered after a reset.
Possible Solution
20
Set the Time & Date
The clock and calendar are utilized to time stamp history records and other
data, so it is important to set the time and date soon after you power on the
display unit.
Set the Time
1. Press the "▲" or "▼" buttons until
2. Press the "
3. Press the "▲" or "▼" buttons to adjust the
4. Press the "
5. Press the "▲" or "▼" buttons to adjust
6. Press the "
The clock is now set.
Note: The " " stays in
Set the Date
Selectable Categories,
1. Press the "▲" or "▼" buttons until
even after setup.
2. Press the "
3. Press the "▲" or "▼" buttons to adjust
4. Press the "
5. Press the "▲" or "▼" buttons to adjust
6. Press the "
7. Press the "▲" or "▼" buttons to adjust
8. Press the "
The date is now set.
"SET CLOCK?" is displayed on the
Selectable Category part of the display
unit.
" button to set the clock.
hour. Note the "AM" and "PM" indicators.
" button to confirm hour
selection.
minutes.
" button to confirm minute
selection.
"SET DATE?" is displayed on the
Selectable Category part of the display unit.
" button to set the date.
the month.
" button to confirm month
selection.
the day.
" button to confirm day
selection.
the year.
" button to confirm year
selection.
9
Advertisement
Table of Contents
