Table of Contents
Advertisement
Assemble the Stand
Assemble the stand on which you will install the printer.
-> Refer to "Assemble the Stand" in the Printer Stand Setup Guide
Install the Roll Unit
Attach the roll unit to the stand.
-> Refer to "Install the Roll Unit" in the Printer Stand Setup Guide
Install the Printer
1
Remove the packaging material on top of
the printer.
5
With three people holding the carrying handles under the printer on both ends, lift the printer.
• The printer alone weighs approximately 2
kg. Moving the printer requires at least six
Caution
people, three on either side. Be careful to
avoid back strain and other injuries.
• When standing the printer up, make sure the
side with the control panel is up, and place
cardboard or other material underneath to
prevent scratching. Furthermore, make sure
that the weight of the printer is taken by the
corner of the printer. If the weight is taken by
any other part of the printer, the printer may
become damaged.
2
While two people hold the carrying handles
under the printer on one end and lift the
printer a little, have a third person remove the
packaging material and the plastic covering
from under the printer. After the packaging
material has been removed, lower the printer.
• When moving the printer, firmly grasp the
carrying handles (a) under each side. Holding
the printer at other positions is dangerous
and cause injury and damage if the printer is
dropped.
a
• When standing up the printer or supporting the
printer, hold the metal parts of the printer. If
you hold a plastic part, the printer may become
damaged.
3
3
Remove the packaging material and the
plastic covering from the other side of the
printer the same way.
4
Pull out the roll unit.
• When setting the printer down temporarily
make sure to put the printer on a flat, stable
place.
• The way to set the printer down or to carry with
the load only to the center of the printer, may
cause damage to the printer.
Advertisement
Table of Contents
