Table of Contents
Advertisement
Load Paper to Adjust the Printhead
Load the included paper and adjust the Printhead.
1
Select type of paper for printhead adj.
is shown on the display screen. Use the
▲ and ▼ keys to select Cut Sheet and
then press OK.
3
Insert the paper included with the printer between the platen (a) and
paper retainer (b) in portrait orientation with the printed side of the
paper facing up.
Load the paper aligned with the paper alignment lines (c) to ensure
that the paper is not crooked, and align the leading edge of the
paper with the front side of the line (d).
When inserted, sheets are automatically held by suction against the
platen.
b
a
5
The screen for selecting the paper type is shown on the display
screen. Press ▲ or ▼ to select the type of paper loaded in the
printer.
Select Coated Paper and then press OK. Then from the menu that
appears, select Coated Paper and then press OK.
Paper begins feeding.
• If Paper loaded crooked. is displayed, reload the cut sheet by
referring to step 3.
MEMO
When you load roll paper after the setup, you need to first press the
Load key and select roll paper as the paper source. For details, refer
to the User's Guide and Basic Guide that can be accessed by the
procedure in "How to Display the Electronic Manuals" (P. 8).
2
Open the top cover and lift the release
lever.
c
d
c
4
Lower the release lever and close the top cover.
6
Once feeding the paper is finished, the printer automatically starts
charging the system with ink and adjusting the printhead. Charging
the system with ink and adjusting the printhead for the first time
takes about 30 minutes.
Install the software on your computer while the printer is working.
(See "Install the Software" on page )
• Charging the system with ink fills the system from the ink tanks
to the printhead. In addition, cleaning is performed to keep the
MEMO
printer in optimal condition. This may cause the remaining ink
indicator and maintenance cartridge capacity indicator to drop
some amount. The starter ink tank is for first-time installation.
It is recommended that you purchase replacement ink tanks
quickly.
Once the printhead adjustment has finished, the paper with the
adjustment pattern printed on it is ejected. Release the release lever
and remove the paper.
This completes the printer setup.
• You can also see the method for loading roll paper using the control
panel navigation function. You can view the navigation using the following
MEMO
procedure.
. Press the Navigate key.
2. Press the ▲ and ▼ keys to select Load Roll Paper and then press the
OK key.
3. Press the ▲ and ▼ keys to select View Op. Guide and then press the
OK key.
The navigation starts.
0
• Do not touch the linear scale (a),
carriage shaft (b), or fixed blade (c).
This may stain your hands and damage
the printer.
a
c
b
Advertisement
Table of Contents
