Assemble The Stand; Install The Printer - Canon Image Prograf PRO-2000 Setup Manual

Assemble the Stand

• Models That Use a Stand
Assemble the stand on which you will install the printer.
-> Refer to "Assemble the Stand" to "Prepare to Install the Printer" in the Printer Stand Setup Guide (separate manual).
• Models That Do Not Use a Stand
Proceed to "Install the Printer".

Install the Printer

1
Remove the packaging material.
3
With 3 people holding the carrying handles under the printer on both ends, lift the printer.
• Moving the printer requires at least 6 people, 3
on either side. Be careful to avoid back strain and
Caution
other injuries due to the weight of the printer.
<Printer weight (printer only)>
- PRO-6000 : Approx. 268 lb (122 kg)
- PRO-6000S : Approx. 260 lb (118 kg)
- PRO-4000 : Approx. 231 lb (105 kg)
- PRO-4000S : Approx. 227 lb (103 kg)
- PRO-2000 : Approx. 185 lb (84 kg)
• When standing the printer up, make sure the side
with the control panel is up, and place cardboard
or other material underneath to prevent scratching.
Furthermore, make sure that the weight of the
printer is taken by the corner of the printer. If the
weight is taken by any other part of the printer, the
printer may become damaged.
2
• When moving the printer, firmly grasp the carrying
handles (A) under each side. Holding the printer at
other positions is dangerous and may cause injury
and damage if the printer is dropped.
A
• When standing up the printer or supporting the
printer, hold the metal parts of the printer. If
you hold a plastic part, the printer may become
damaged.
3
Remove all of the tape and other packaging material. Open the top
cover (A) and output guide (B), and then remove the tape affixed to
the roll holder.
A
B
• When setting the printer down temporarily, make
sure to put the printer on a flat, stable place.
A
• Carrying the printer with only the center of the
printer loaded may cause damage to the printer.