Assemble The Stand; Install The Printer - Canon imagePROGRAF iPF825 Setup Manual

Assemble the Stand

For stand assembly instructions, refer to the Printer Stand Setup Guide provided with the stand.
Install the Roll Unit
For roll unit installation instructions, refer to the Printer Stand Setup Guide provided with the stand.

Install the Printer

1
Remove the packaging material on top
of the printer.
Instructions for iPF825
4
Pull out the roll unit.
6
Align the triangles on the back of the printer and Stand when setting the printer on the
Stand. Secure the printer and Stand fi rmly together using four M4 hex screws on each side
by the Allen Wrench.
Assemble the stand, in preparation for printer installation.
Install the roll unit on the stand. (iPF825 only.)
Mount the printer on the stand.
2
While two people hold the carrying handles
under the printer on one end and lift the
printer a little, have a third person remove the
packaging material and the plastic covering
from under the printer. After the packaging
material has been removed, lower the printer.
5
With three people holding the carrying handles under the printer on both ends, lift the printer.
• The printer alone weighs approximately
112 kg. Moving the printer requires at least
Caution
six people, three on either side. Be careful
to avoid back strain and other injuries.
3
3
Remove the packaging material and the
plastic covering from the other side of the
printer the same way.
• When moving the printer, fi rmly grasp the
carrying handles (a) under each side. Holding
the printer at other positions is dangerous
and cause injury and damage if the printer is
dropped.
a
Instructions for iPF825
7
Push in the roll unit.