Messages - Sony MHC-RV990D Operating Instructions Manual

If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the unit for the operation.
1
Disconnect the power cord.
2
Reconnect the power cord.
3
Press x, GROOVE and DISPLAY at the
same time.
4
Press ?/1 to turn on the system.
The system is reset to the factory settings except
for DVD settings. You should set the settings
you made, such as the preset stations, clock, and
timer.
To return the DVD setup to the
default settings, perform reset as
follows:
1
Press DVD SETUP in stop mode.
2
Press M or m repeatedly to select "RESET",
then press ENTER.
3
Press M or m repeatedly to select "YES",
then press ENTER.
It takes a few seconds to complete. Do not
press ?/1 when resetting the system.
Note
Turn off the sub woofer before you reset the system.

Messages

One of the following messages may appear or
flash in the display during operation.
DVD/VIDEO CD/CD/MP3/JPEG
CANNOT PLAY
• A disc that cannot be played was inserted.
• A disc with an unsupported Region code was
inserted.
DATA ERROR
The JPEG file is an unsupported format.
NO DISC
There is no disc in the unit.
NOT IN USE
You pressed an invalid button.
PLAY LIMIT
The MP3 file cannot be played.
PUSH STOP
You pressed PLAY MODE during play.
STEP FULL
You tried to program 26 or more tracks (steps).
READING
The system is reading TOC information of the disc.
Some buttons are not available.
Tape
NO TAB
You cannot record the tape because the tab has been
removed from the cassette.
NO TAPE
There is no tape in the tape deck.
GB
65