Power Connector And Cable - HP ProBook 430 G3 Maintenance And Service Manual

Power connector and cable

Description
Power connector and cable
Before removing the power cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Service door (see
b. Keyboard (see
c. Hard drive
d. Top cover (see
e. Display assembly (see
Remove the power cable:
1. Remove the 2 Phillips PM2.5×5.0 screws (1) from the left display hinge.
2. Rotate the left display hinge upward (2).
3. Disconnect the cable from the system board (3).
Battery on page
Service door on page
Keyboard on page 44)
(Hard drive on page 35)
Top cover on page 49)
Display assembly on page
33).
34).
72)
Component replacement procedures
Spare part number
827039-001
77