HP ProBook 430 G3 Maintenance And Service Manual page 87

10. If it is necessary to remove the display panel from the enclosure, remove the 4 Phillips PM2.0×4.0
screws (1) that secure the panel to the display enclosure, and then rotate the top of the panel all the
way over (2).
The raw display panel is available using spare part number 826377-001.
11. Lift the cable connector bracket (1), disconnect the display cable from the rear of the panel (2), and then
remove the display panel (3) from the enclosure.
12. If it is necessary to replace the display hinges, remove the 3 Phillips PM2.0×3.0 screws at the bottom of
each hinge (1).
Component replacement procedures 75