Yamaha YZF-R1(B) 2012 Service Manual page 468

Fault code No.
Symptom
Fail-safe action
Diagnostic monitor-
ing code No.
Meter display
Checking method
Item/components and
probable cause
2 Connection of main harness
ECU coupler
Check the connection of the
coupler is secure.
Remove the coupler, and
check each pin (for bending,
wear, or locking).
3 Connection of ignition system
sub-wire harness coupler
Check the connection of the
coupler is secure.
Remove the coupler, and
check each pin (for bending,
wear, or locking).
4 Continuity of wire harness
5 Ignition coil installation status Check the mounting section
35
Ignition coil #3 primary lead malfunction
Engine startup: Possible (depending on the number of failed cylin-
ders)
Riding: Possible (depending on the number of failed cylinders)
D:32
Actuates the cylinder-#3 ignition coil five times at one-second inter-
vals.
Illuminates the engine trouble warning light.
Check the spark five times.
• Connect an ignition checker.
Check or maintenance job
Poor connection → Connect
it securely or replace the wire
harness.
Poor connection → Connect
it securely, or repair/replace
the wire harness.
Open or short circuit →
Replace the wire harness.
Orange/Green–Orange/
Green
for a loose or pinched mount-
ing.
Make sure that the mounting
position is correct.
FUEL INJECTION SYSTEM
8-71
Sensor inspection proce-
dure
Start and idle the engine for
approximately 5 seconds.
Then, check the fault code
indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
Start and idle the engine for
approximately 5 seconds.
Then, check the fault code
indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
Start and idle the engine for
approximately 5 seconds.
Then, check the fault code
indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
Start and idle the engine for
approximately 5 seconds.
Then, check the fault code
indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.