3. Tighten:
• Cap bolt "1"
Cap bolt
20 Nm (2.0 m·kgf, 14 ft·lbf)
• Handlebar bolt "2"
Handlebar bolt
13 Nm (1.3 m·kgf, 9.4 ft·lbf)
• Handlebar pinch bolt "3"
Handlebar pinch bolt
16 Nm (1.6 m·kgf, 11 ft·lbf)
• Upper bracket pinch bolt "4"
Upper bracket pinch bolt
26 Nm (2.6 m·kgf, 19 ft·lbf)
4. Check:
• Cable routing
TIP
Make sure the brake hose, throttle cables,
clutch cable, and handlebar switch leads are
routed properly. Refer to "CABLE ROUTING"
on page 2-49.
5. Install:
• Plastic band "1"
TIP
Fasten the front brake hose to the right front
fork leg with the plastic locking tie.
6. Adjust:
• Spring preload
• Rebound damping
• Compression damping
Refer to "ADJUSTING THE FRONT
FORK LEGS" on page 3-25.
4-71
FRONT FORK