EWA13400
WARNING
If the connecting rod bolt is tightened more
than the specified angle, do not loosen the
bolt and then retighten it. Instead, replace
the connecting rod bolt with a new one and
perform the procedure again.
ECA13950
Do not use a torque wrench to tighten the
connecting rod bolt to the specified angle.
d. After the installation, check that the section
shown "a" is flush with each other by touch-
ing the surface.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
CONNECTING RODS AND PISTONS
5-84