Yamaha YZF-R1(B) 2012 Service Manual page 175

b. When adjusting the right rider footrest,
change the position of the hole "a" of the
exhaust chamber cover "2".
Exhaust chamber cover bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
c. Adjusting the right rider footrest "1".
d. Adjusting the left rider footrest "1".
ECA14B1024
Route the rear brake light switch lead
through the groove "1" of the right rider
footrest and groove "2" of the exhaust
chamber cover.
TIP
When adjusting the left and right rider footrest,
be sure to set them on the same level.
e. Install the rider footrest bolts.
Rider footrest bolt
28 Nm (2.8 m·kgf, 20 ft·lbf)
TIP
• Install the end "a" of the exhaust chamber
cover "1" within the range "b" of the exhaust
chamber upper cover "2" as shown in the
illustration.
• After adjusting the right rider footrest, adjust
the rear brake pedal and rear brake light
switch.
Refer to "ADJUSTING THE REAR DISC
BRAKE" on page 3-16 and "ADJUSTING
THE REAR BRAKE LIGHT SWITCH" on
page 3-33.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
4-16
GENERAL CHASSIS