First Infeed Screw Loading; Extra Fan Blow - Ravelli o-ring User Manual

pressed down until a turned off LED starts rotating counter-clockwise: release
the key. The stove will perform a final cleaning and the animation will remain
active until complete cooling of the stove, after which it will go in OFF state,
displaying the relative animation

first infeed screw loading

The O-Ring allows you to execute the first infeed screw loading after having
filled up the pellet tank, to achieve a correct ignition. Proceed from OFF state,
turning the push-button/dial clockwise: each step will cause the 6 BLUE LEDs
to turn on. Every 6 LEDs lit up correspond to 30 seconds of loading. It will take 5
sec for the function to become active; if activation is not performed, the O-Ring
returns to OFF state.
Press the button for 2 sec: the infeed screw will be activated, loading pellets.
If you do not manage to load the infeed screw completely through one opera-
tion, repeat the operation until the brazier will be full with pellets. This is not a
failed ignition. Therefore, the pellets can be used again, putting them back into
the tank.
If the function is activated by mistake or the infeed screw is already full, the
loading cycle can be interrupted by pressing the button once; the stove will go
back to OFF state.
30 sec. >> 6 LEDs lit

extra fan blow

Due to its innovative O-ring, the Ravelli Young stove allows the user to vary the
blow of room fan for each of the 12 powers of the stove. This feature is par-
ticularly useful as it allows to increase or decrease the blow of hot air output
by the stove, without varying the amount of pellets burned.
During operation at any power, briefly press the O-Ring button: the following
LED display will appear: in the bottom display,
the left and
towards the red (increased blow) or decrease toward the blue (decreased
blow); on the top display, 2 BLUE LEDs will light up, one to the right and one
to the left, indicating the power of EXTRA blow.
In the center, NORMAL blow (like in the figure). There are 3 increases and 3
decreases available, which will add or remove 10 Volts to/from the current
speed of the fan.
counter-clockwise, the
hot blow speed will be
If the stove is operating at minimum power (P1), there will be no change if the
blow is further decreased; under these conditions, in the opposite case, if the
stove is operating at maximum power (P12), there will be no change if the blow
60 sec. >> 12 LEDs lit will be further increased, as the fan is already operating at the scale limits set
23
90 sec. >> 18 LEDs lit
3 RED LEDs
on the right, indicating the direction of the increase
NORMAL BLOW - AS PER RATED POWER
By turning the dial
decreased
USER MANUAL
O-RING
120 sec. >> 24 LEDs lit
3 BLUE LEDs
will light up on
By turning the dial
clockwise, the hot blow
speed will be increased