Examples Of Installation Of A Pellet Insert - Ravelli o-ring User Manual

This type of installation (see fig. 6) requires a horizontal section for connection
to an existing flue. Comply with the slope indicated in the figure, to reduce de-
positing ash in the horizontal tube section. In the lower part of the flue duct was
installed a T fitting with inspection plug like for the flue inlet.
It is not recommended to install a 90° curve as the first piece, since the ash
could quickly obstruct the smoke passage, compromising stove draught. (See
fig.2)
Protection from rain
T fitting with collection and
condensate chamber
fig.6
Inspection door
19

examples of installation of a pellet insert

In this type of installation we can notice that the fitting was used to enable
connecting the insert to the chimney (so-called "bayonet" mount). For safety
reasons and to ensure proper operation, we recommend you fit pipes into the
7). It is recommended to perfectly match the insert with the fit-
chimney. (Fig.
ting, to prevent leaks of smoke during the work phase.
Exploded view of T fitting
fig.7
USER MANUAL
O-RING
Protection from rain
Pipe
T fitting with inspection
ash collector cap