Preliminary Operations; Wiring; How To Load The Pellets; O-Ring Description - Ravelli o-ring User Manual

PrelImInary oPeratIonS

Wiring

Connect the power cord to the back of the stove and then to
a wall socket.
The I/O switch in the figure should be set to I to power
the stove. If voltage is not supplied check the state of the
fuse installed in the box below the switch (4A fuse). During
the periods of inactivity, we recommend you disconnect the
power cord of the stove.
What to check befor turning on the stove
Make sure you have removed all parts that pose the risk of burns from the
combustion chamber or glass (various instructions or stickers). Before turning
on the stove, make sure you have fitted the grate on the support base and check
that the door and the ash drawer are properly close.

how to load the pellets

Fuel supply consists in the insertion of pellets from
the top of the stove, by opening the door. During
pellet loading prevent the pellet bag from coming
into contact with hot surfaces.
!
NEVER INSERT INTO THE TANK OTHER KIND OF FUEL OTHER FROM THE
PELLETS COMPLYING WITH THE SPECIFICATIONS BELOW

o-rInG deScrIPtIon

The O-ring device is shown in the picture below:
The O-Ring graphical representation is minimal, to better highlight its main fea-
ture: simplicity. In the following pages we shall see how to use the device to
control the Ravelli Young pellet stove. The O-Ring interacts with the user by
means of 4 sets of 6 LEDs each. The latter propose animations in intense BLUE
or RED light, depending on the phase or the situation.
Thanks to its simplicity, the O-Ring enables:
1.
signalling the OFF state;
2.
by holding it pressed down for 4/5 seconds, it switches the stove ON and
OFF;
3. it INCREASES or DECREASES the intensity of the heat output by the stove,
using 12 powers;
4. it enables a fine-tunning of room fan on each of the 12 powers;
5.
it signalls the user all OPERATION and ALARM states;
6.
It does not provide date and time setting, thermostat setting- absent function
- nor room temperature setting. The temperature will be adjusted by the user
by increasing or decreasing the power, depending on the heat or cold sensation
perceived inside the home or at the place of use.
CONVENTION FOR THE PICTURES IN THIS MANUAL: The pictures of the O-Ring
are reproduced in cartoon-type pictures for easy printing. The lamps and the
different colors are represented with arrows and various indicators for easy
understanding.
21 USER MANUAL
O-RING
Multi-purpose Potentiometer and
Key / Push-button
LED status indicators