Select (Top-Level) Menu; Select: Config (Configuration) - Comtech EF Data CRS-300 Installation And Operation Manual

CRS-300 1:10 Redundancy Switch
Front Panel Operation
7.3

SELECT (Top-Level) Menu

SELECT:
MONITOR
Move the cursor to the desired choice using the ◄ ► arrow keys, then press
following table describes the function of each menu branch (along with the section in this chapter
that provides information on that branch and its accompanying submenus):
Selection
CONFIG
INFO
MONITOR
STORE/LD
UTIL
7.4

SELECT: CONFIG (Configuration)

CONFIG:
OPTIONS
Move the cursor to the desired choice using the ◄ ► arrow keys, then press
The submenus available under the CONFIG menu branch are as follows:
Selection
MANUAL
AUTO
[OFF/ON]
OPTIONS
REMOTE
ACTIVE
IMPORTANT
CONFIG INFO
STORE/LD UTIL
Sect. Menu Branch Description
7.4 (Configuration) Permits the User to fully configure the Switch.
(Information) Permits the User to view information on the Switch, without
7.5
having to go into configuration screens.
Permits the User to monitor the status of the Switch and view the log of
7.6
stored events for both the Switch and its attached modems.
(Store/Load) Permits the User to store and to retrieve up to 10 different
7.7
Switch configurations.
(Utility) Permits the User to perform miscellaneous functions, such as
7.8
setting the Real-time clock, adjusting the display brightness, etc.
MANUAL AUTO[OFF]
REMOTE ACTIVE
Sect. Submenu Description
Permits the User to select which traffic MODEM the Switch should bridge
7.4.1
or backup.
Permits the User to turn Auto mode off or on. The currently selected state
7.4.2
is always shown on this menu
Permits the User to set several operating parameters of the Switch that
7.4.3 pertain to enabling or disabling the availability of Traffic Modems, the
reporting of faults and time delays for responding to faults.
7.4.4 Permits the User to define the remote control settings.
7.4.5 Permits the User to activate modems, if a TMI is present.
The Switch may be monitored over the remote control bus at any time.
When in Local mode, however, configuration parameters may only be
changed through the front panel. Conversely, when in Remote mode,
the unit may be monitored from the front panel, but configuration
parameters via may only be changed remote control bus.
7–7
Revision 16
MN/CRS300.IOM
. The
[ENT]
[ENT] .