Maintenance - Bosch ALS 2500 Original Instructions Manual

OBJ_BUCH-1807-004.book Page 5 Tuesday, May 26, 2015 8:16 AM
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
2
– 1.0 mm : max. length 40 m
2
– 1.5 mm : max. length 60 m
2
– 2.5 mm : max. length 100 m
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
your supply network in accordance
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service Cen-
tre.
 WARNING! Inadequate extension
cables can be dangerous. Exten-
sion cable, plug and socket must be
of watertight construction and in-
tended for outdoor use.
It is recommended for increased elec-
trical safety to use a Residual Current
Device (RCD) with a tripping current of
not more than 30 mA. Always check
your RCD every time you use it.
The connection lead must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cord is damaged, it must
be replaced by a Bosch Service Centre.
For products not sold in GB:
WARNING: For your safety, it is re-
quired that the plug attached to the ma-
chine is connected with the extension
cord. The coupling of the extension
cord must be protected against splash
water, be made of rubber or coated
with rubber. The extension cord must
be used with a cable strain relief.
Bosch Power Tools
 Products sold in GB only: Your prod-
uct is fitted with a BS 1363/A ap-
proved electric plug with internal fuse
(ASTA approved to BS 1362).
If the plug is not suitable for your
socket outlets, it should be cut off
and an appropriate plug fitted in its
place by an authorised customer ser-
vice agent. The replacement plug
should have the same fuse rating as
the original plug.
The severed plug must be disposed of
to avoid a possible shock hazard and
should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only:
Use a residual current device (RCD)
with a rated residual current of 30 mA
or less.

Maintenance


Keep all nuts, bolts and screws tight
to ensure that the leaf blower/garden
vacuum is always in a safe working
condition.
 The leaf blower/garden vacuum
should be stored in a dry, high or
locked up place out of the reach of
children.
 Replace worn or damaged parts for
safety.
 Check the collection bag frequently
for wear or deterioration.
 Do not attempt to repair the machine
unless you are qualified to do so.
 Ensure replacement parts fitted are
Bosch approved.
English | 5
F 016 L70 941 | (26.5.15)