Chapter 3. Chassis; Steering Installation - Yamaha RX10K Supplementary Service Manual

STEERING
CHASSIS
STEERING
INSTALLATION
1. Install:
S Relay arms 1
S Bushings
S Washers 2
Bolt (relay arm):
67 Nm (6.7 mSkg, 49 ftSlb)
S Clips 3
2. Install:
S Idler arm 4
S Bushings
S Washers
S Relay rod 5
Nut (idler arm):
35 Nm (3.5 mSkg, 25 ftSlb)
Nut (relay rod):
30 Nm (3.0 mSkg, 22 ftSlb)
3. Install:
S Tie rod 1
S Locknuts 2
S Joints 3
Tie rod
A
part number
8FA-23830-00 418.0 mm
(16.4567 in)
4. Check:
S Tie rod angle a
Tie rod angle:
47_
CAUTION:
After tightening the inside and outside ball
joint locknut 2 , make sure the tie rod 1 can
be rotated freely through the ball joint travel.
If not, loosen the locknut 2 and re-position
the ball joint so that the tie rod 1 can br ro-
tated freely. Tighten the locknut to specifica-
tion.
17
CHAS
Set Tie rod
B C
length
a b
length
355.0 mm
(13.9764 in)
3