Yamaha RX10K Supplementary Service Manual page 199

REAR SUSPENSION
Control rod
1. Adjust:
S Control rod stroke a
CAUTION:
Make sure the adjusting bolt ends are set at
the same position on each side.
Adjustment steps:
S Loosen the lock nut 1 .
S Turn the adjusting nut 2 in or out to adjust the
control rod stroke.
Adjusting
1
position
Increase
Effect
weight transfer
Standard
WARNING
Never adjust the control rods beyond the
maximum range indicated on the rods with
red paint 3 .
S While holding the adjusting bolt securely, tight-
en the locknut 1 .
Locknut:
25 Nm (2.5 mSkg, 18 ftSlb)
Rear suspension position (RX10M,
RX10MS)
1. Adjust:
S Rear suspension position
NOTE:
Select the rear suspension position according
to the snow conditions: a standard; b deep
new snow.
Bolt (slide rail suspension):
72 Nm (7.2 mSkg, 52 ftSlb)
2-73
INSP
ADJ
2 3 4
Decrease
pitching
3