Yamaha RX10K Supplementary Service Manual page 461

REAR SUSPENSION
Control rod
1. Check
S Control rod bolt a
Bolt (control rod bolt):
32 Nm (3.2 mSkg, 23 ftSlb)
2. Adjust:
S Control rod stroke a
CAUTION:
Make sure the adjusting bolt ends are set at
the same position on each side.
Adjustment steps:
S Loosen the lock nut 1 .
S Turn the adjusting nut 2 in or out to adjust the
control rod stroke.
Adjusting
1
position
Increase
Effect
weight transfer
Standard
WARNING
Never adjust the control rods beyond the
maximum range indicated on the rods with
red paint 3 .
S While holding the adjusting bolt securely, tight-
en the locknut 1 .
Locknut:
25 Nm (2.5 mSkg, 18 ftSlb)
16
INSP
ADJ
2 3 4
Decrease
pitching
3