Rear Suspension - Yamaha RX10K Supplementary Service Manual

REAR SUSPENSION

Adjustment steps:
S Loosen the locknut 1 .
S Turn the adjusting nut 2 in or out to adjust the
stopper band tension.
15 ± 0.5 mm (0.59 ± 0.02 in)
Adjuster
thread Maximum: 35 mm (1.37 in)
length Minimum: 10 mm (0.40 in)
a
Effects Longer
More weight on skis;
Less weight transfer
Shorter
Less weight on skis;
More weight transfer
S Tighten the locknut.
Locknut:
16 Nm (1.6 mSkg, 12 ftSlb)
Rear suspension damping force adjustment
The damping force can be adjusted by turning
the adjuster 1 .
16 clicks
out
Adjuster j
position
Turns out z
Damping
Soft z
force
* With the adjuster fully turned lightly in direction
a
CAUTION:
S Do not continue to turn the adjuster in
direction a after it stops. The shock ab-
sorber can be damaged and damping force
adjustments cannot be made.
S Do not turn the adjuster in direction b
more than 16 clicks. Even if the adjuster is
continually turned after 16 clicks, there will
be no change in the damping force.
S Be sure to stop the adjuster at a position
where there is a click.
15
INSP
ADJ
7 clicks 1 click
out out
Minimum Minim m Standard Standard Maximum Maxim m
! Turns in
b *
a
! Hard