Yamaha RX10K Supplementary Service Manual page 512

1 Right handlebar switch
2 Clamp the main harness, main
switch and harness.
3 Clamp the grip warmer lead
and the right handlebar switch
lead.
4 Throttle cable
5 Handlebar holder
6 Pass all leads and cables
through the cable holder. (Ex-
cept for brake hose and parking
brake cable.)
7 Clamp the tail / brake light lead,
headlight beam switch lead
and grip warmer lead.
8 Parking brake cable
9 Left handlebar switch
10 Pass the brake hose and the
parking brake cable through
the cable holder.
Clamp the fuel sender lead and
11
speed sensor lead.
Speed sensor lead coupler
12
Clamp the fuel tank breather
13
hose.
Fuel sender lead cover
14
Route the fuel tank breather
15
hose along the frame cross
member.
Clamp the speed sensor lead
16
only.
17 Clamp the compression spring
section of the fuel tank breather
hose.
18
Compression spring
19 Carburetor air vent hose
20 Breather tank
21 Pass the fuel hose over the en-
gine oil breather hose.
22 Point the clip position to the up-
ward.
23 Insert the fuel tank breather
hose until it contacts the projec-
tion.
24
Pass the carburetor air vent
hose outside of the engine oil
breather hose.
25
To the speed sensor.
CABLE ROUTING
67
SPEC