EUROCOM Shark 5 User Manual page 195

Problem
The Wireless LAN/Bluetooth modules
cannot be detected.
The PC Camera module cannot be
detected.
The Wireless LAN/Bluetooth modules
cannot be configured.
A file cannot be copied to/from a
connected Bluetooth device.
No sound can be heard through an HDMI
connected display.
Audio Volume is too low when listening
through headphones.
Possible Cause - Solution
The modules are off as the computer is in Airplane Mode. Check the LED
indicator to see if it is in Airplane Mode (see
10). Use the Fn + F11 key combination to toggle Airplane Mode on/off (see
Table 1 - 4, on page 1 - 16).
The module is off. Press the Fn + F10 key combination in order to enable the
module (see "Function Keys & Visual Indicators" on page 1 -
camera application to view the camera picture.
The driver(s) for the module(s) have not been installed. Make sure you have
installed the driver for the appropriate module (see the instructions for the
appropriate module in "Wireless LAN Module" on page 6 - 2
"Bluetooth & WLAN Combo Module" on page 6 -
The transfer of data between the computer and a Bluetooth enabled device is
supported in one direction only (simultaneous data transfer is not
supported). If you are copying a file from your computer to a Bluetooth enabled
device, you will not be able to copy a file from the Bluetooth enabled device to
your computer until the file transfer process has been completed
You have not configured the HDMI audio output. See
Configuration" on page C -
You have set the Speaker Configuration to 5.1 or 7.1 Speaker. It is
recommended that you set the Speaker Configuration to Stereo (not to 5.1 or
7.1 Speaker) when listening through headphones in order to maximize audio
quality. See "Audio Features" on page 2 -
Problems and Possible Solutions 7 - 11
Troubleshooting
"LED Indicators" on page 1 -
12).
9.
7.
16). Run the
and/or
7
"HDMI Audio