DTK PAM-0057I User Manual page 40

Chapter 4
A short description of the screen items follows:
ACPI Function: To enable feature for supporting the operating system with Advanced
Configuration and Power Interface. (such as Windows 98)
Power Management: Available selection are "Disabled", "User Define", "Max Saving" and
"Min Saving":
"Disabled" will disable all the power saving function.
"User Define" makes the time period waiting for Suspend Mode to be programmed.
"Max Saving" will set the time period waiting for Suspend Mode to be 10 seconds.
"Min Saving" will set the time period waiting for Suspend Mode to be 1 hour.
PM Control by APM: Choose Yes or No. Yes means the Power Management Function can be
control by the MS APM software.
Video Off Method: Choose V/H SYNC+Blank, DPMS or Blank Screen. This is monitor Power
Saving Method. V/H SYNC+Blank means turn off Vertical, Horizontal scanning and blank the
screen. Blank Screen will blank the display screen. DPMS (Display Power Management
System) can allow the System BIOS control the Display Card to turn off the Display.
Video Off After: As the system moves from lesser to greater power-saving modes. Select the
mode in which you want the monitor to blank. The available options are "Standby", "Suspend",
"Doze" and "NA".
Suspend Mode: To set the time period waiting for Suspend Mode when the Power Management
function is set to "User Define".
HDD Power Down: To select the time period will turn the HDD off. Access the HDD again will
take a few seconds for HDD to spin back to normal speed for data.
IRQx (Wake-up Event): When it is enabled, the system will monitor each ON event which also
is "ON" on the right side device, once one of those device (IRQx) is triggered the system will go
back from Doze, Standby Mode to normal state.
34