Recording A Current Broadcast In Analog (S-Vhs/S-Vhs Et/Vhs) Format - Mitsubishi HS-HD2000U Owner's Manual

Recording
Recording a Current Broadcast in Analog (S-
VHS/S-VHS ET/VHS) Format
1 Load a tape with its erasure prevention tab intact into the VCR.
2 Select the recording format. See Selecting Recording Format on page 32.
3 Select the speed at which you would like to record by pressing SP/EP on the
remote control or on the front panel.
4 Set the VCR's input to tuner by pressing INPUT until a channel number is
shown on-screen or on the front panel display. If L1 or L2 appears instead of a
channel number, continue to press INPUT until a channel number appears. To
record channels from a PRIMESTAR
number with the PRIMESTAR light (
5 Select the channel you wish to record by pressing CHANNEL or the number
buttons on the remote or the jog dial on the front panel. If you are using a
cable box that the VCR cannot control, select channel 3 or 4 on the VCR, and
change the channel on the cable box, not on the VCR.
6 Press REC on the remote or REC/˙REC LENGTH on the front panel.
Recording will start. When the VCR reaches the end of the tape, it will automati-
cally rewind to the beginning of the tape and stop.
• You can stop recording at any time by pressing STOP or PAUSE on the remote
or on the front panel.
• To resume recording from STOP, press REC.
• To resume recording from PAUSE, press PAUSE.
You cannot use REC/˙REC LENGTH on the front panel to resume recording
from PAUSE.
If you pause the VCR for more than five minutes, recording will stop
automatically to protect the tape.
If you record in extended play (EP), you will only be able to play the tape on
a VCR equipped for EP play, such as this one.
28
® receiver, press INPUT until a channel
) appears on the front panel display.
IMPORTANT
CHANNEL
REC
JOG/CHANNEL
SP/EP
2 REC LENGTH
STOP
SP/EP
INPUT
STOP
PAUSE
REC
PAUSE