Table of Contents
Advertisement
Hooking Up Your VCR
Connections to IR Emitter
Your VCR will be able to send remote control channel
changing commands to your compatible cable box or
satellite receiver. The VCR uses the IR Emitter to send
these commands in the same way as when you use the
hand held remote that came with the cable box or re-
ceiver.
1
Connect the supplied IR Emitter to CONVERTER
BOX CONTROL on back of the VCR.
2
Run the wire under or along side the cable box or
satellite receiver and place the end in front of the
cable box and/or satellite receiver.
3
Use the double stick tape to secure the end of the
emitter in the proper place.
VCR Rear Panel
If you connect both a cable box and satellite re-
ceiver, place the IR Emitter to face the remote
control window (sensor) in the front of both. If you
cannot place it this way, you can purchase a dual IR
Emitter from your Mitsubishi dealer.
CONVERTER
BOX CONTROL
Cable Box or Satellite Receiver
IMPORTANT
IR Emitter
11
Hide quick links:
Advertisement
Table of Contents
