Mitsubishi HS-HD2000U Owner's Manual page 11

Hooking Up Your VCR
Connections to Satellite Receiver
If you have an Mitsubishi DSS
Toshiba DSS ® , Panasonic DSS
PRIMESTAR ® , or DISH Network
can connect the satellite receiver to your VCR and then
set up the VCR to change the channels of the satellite
receiver. This will allow you to program your VCR to
make unattended recordings from several different
satellite channels.
1 Connect the red and white audio cable to AUDIO
OUT R and AUDIO OUT L on the satellite receiver.
Connect the other end to the AUDIO IN R and AUDIO
IN L on the back of the VCR. Match the colors of the
connectors to the cables.
2 Connect the S-video cable to S-VIDEO OUTPUT on
the satellite receiver. Connect the other end to the S-
VIDEO IN on the back of the VCR.
If your satellite receiver does not have S-VIDEO
OUTPUT, connect the video cable to VIDEO
OUTPUT on the satellite receiver. Connect the other
end to the VIDEO IN on the back of the VCR.
3 See page 11 for IR Emitter connection.
connecting both a satellite receiver and a cable box
with audio video outputs
1 Connect the satellite receiver to the audio video
inputs on the back of the VCR as shown.
2 Connect the cable box to the audio video inputs on
the front of the VCR.
Red
® , RCA DSS ® , Sony DSS
® , Hughes DSS ® ,
™ satellite system, you
VCR Rear Panel
R AUDIO L/MONO VIDEO S-VIDEO
IN 1
R L
optional
S-video cable
White Yellow
Connect it only if the satellite
receiver does not have S-Video
Output.
optional video cable
optional audio cable
® ,
You cannot connect both a satellite receiver and a
digital cable box.
You may need to purchase an audio cable and an S-
video cable for this hookup.
If possible, you should have connected your VCR to
your TV with an S-Video cable. It will allow you to
watch the satellite video signal on your TV even
when the VCR is off if you set the Rear S-through in
the S-VHS Set-Up menu to ON.
If you connect your VCR to your TV with a standard
video cable, you will have to turn the VCR on to
watch the video signal from the satellite receiver.
You will be able to hear the audio signal from your
satellite receiver both when the VCR is on and off.
When you connect a satellite receiver to the S-video
input on the back of the VCR, you have to set the
Rear S-input in the S-VHS Set-Up menu to ON.
Refer to your Satellite Receiver Owner's Guide for
Satellite dish to Satellite receiver connections, as
well as other possible video connections to your TV.
DSS ® is a registered trademark of DirecTV, Inc.
PRIMESTAR ® is a registered servicemark of PRIMESTAR Partners LP.
™
DISH Network is a registered trademark of EchoStar Communications Corp.
Satellite Receiver Rear Panel
S-VIDEO
VIDEO L AUDIO
OUT
OUT
L
White
Yellow
IMPORTANT
R
R
Red
9