Brakes - Ossa Explorer User Manual

Checking the crankcase oil
Filling and draining the crankcase
Crankcase oil is used for lubricating the change pedal and the
clutch. Check the oil level with the indicator located on the lower
part of the clutch cover, which is on the right side of the engine. The
oil level should be lower than the indicated maximum level.
MAX.
Optimum oil level
MIN.
The oil level should be checked when the
motorcycle is in an upright position and
on a at surface. The motorcycle should be
cold. If it is not cold, wait some minutes
until it goes cold.
To add oil, remove the cap (A) located on the top of the clutch
cover (D). Use a funnel to add the oil, NEVER filling above the
Maximum level. Replace the cap. If you fill above the Maximum
level, oil must be removed. To remove oil from the hood, place a
receptacle under the motorcycle and remove the lid (B) located
on the side of the hood, and the screw (E), and lean the bike over
in both directions to ensure that no oil remains inside the hood.
46
OSSA EXPLORER - User manual
IMPORTANT: Clean the plug and change the
sealing washer each time the oil is changed.
The crankcase has a 450cc oil capacity. 2T 100%
synthetic oil should always be used.
(A)
Clutch cover (D)
Indicator
(E)
Ignition cover (C)
(B)
The brakes permit precise and controlled riding. It is necessary
to check them in order to ensure that they work correctly.
Wear on the front and rear brake pads
must be periodically controlled so that the
brakes work effectively.
The oil level can be checked using the
indicator on the front handle and on the
rear pump tank. The oil level should be
situated between the min and max values.
To remove surplus air from the break
circuit, the calipers are equipped with air
bleeds. See image.

Brakes

MAX.
MIN.
47
OSSA EXPLORER - User manual