Name Of Each Part - Mitsubishi AJ65SBT-64AD User Manual

4 SETUP AND PREPARATION BEFORE OPERATION

4.3 Name of Each Part

2-piece
(CC-Link
communication
section)
[Terminal numbers and signal names]
1
Name and
Number
appearance
Operation status
1)
display LED
Offset/gain
2)
adjusting LEDs
SELECT/SET
3)
switch
The name of each part in the AJ65SBT-64AD is shown.
1) 2)
PW RUN L RUN L ERR. CH1 2 3 4 OFFSET GAIN
MITSUBISHI A
J65SBT-64AD
DA DG +24V 24G
TEST
DB SLD (FG)
3 5 7 8
DA DG +24V 24G TEST
2 4 6 9
DB SLD (FG)
ON : Power supply on
PW LED
OFF: Power supply off
Normal mode
RUN LED
Test mode
On
L RUN LED
Off
On
Flicker at fixed intervals
L ERR. LED
Flicker at unfixed intervals : Indicates that you forgot fitting the termination resistor or
Off
CH Normal mode
OFFSET
Test mode
GAIN
Used to make offset/gain setting in the test mode.
3)
STATION NO.
SELECT 40 20 10 8 4 2 1
SET
CH1 CH2 CH3
V+ I+ V+ I+ COM
TEST COM SLD COM V+ I+
6)
7)
10 12 14 16 18
V+ I+ V+ I+
11 13 15 17
TEST COM SLD COM V+
Description
On : Normal operation
Flashing : 0.1s intervals indicate an input range setting error.
Off : 24VDC power supply shutoff or watchdog timer error
occurred.
On : Indicates that the SELECT/SET switch is in the SET
position.
Flashing : 0.1s intervals indicate that the input range setting is not
any of "user range settings 1 to 3".
0.5s intervals indicate that you attempted to make
offset/gain setting outside the setting range.
Off : Indicates that the SELECT/SET switch is in the
SELECT or center position.
: Normal communication
: Communication cutoff (time expiration error)
: Indicates that transmission speed setting or station number setting is
outside the range.
: Indicates that transmission speed setting or station
number setting was changed from that at power-on.
the module or CC-Link dedicated cable is affected by
noise.
: Indicates normal communications.
Normally OFF.
The LEDs lit change every time the SELECT/SET switch is moved
to SELECT. (Refer to Section 4.4.)
4 - 3
4) 5)
B RATE
4 2 1
ON
CH4
SLD COM AG
V+ I+
(FG1)
20 22 24
COM SLD COM AG
19 21 23 25
I+ V+ I+ FG1
MELSEC-A
Direct-coupled
(Analog I/O section)