Name Of Each Part - Mitsubishi AJ65SBT-64AD User Manual

3. Name of Each Part

The name of each part in the AJ65SBT-64AD is shown.
2-piece
(CC-Link
communication
section)
[Terminal numbers and signal names]
Name and
Number
appearance
Operation
1) status
display LED
1) 2)
PW RUN L RUN L ERR. CH1 2 3 4 OFFSET GAIN
MITSUBISHI A
J65SBT-64AD
DA DG +24V 24G
TEST
DB SLD (FG)
TEST
1 3 5 7 8
+24V 24G
DA DG TEST
2 4 6
9
DB SLD (FG) TEST
ON : Power supply on
PW LED
OFF : Power supply off
On
Normal Flashing : 0.1s intervals indicate an input range error.
mode Off
On
RUN LED
Flashing : 0.1s intervals indicate that the input range
Test
mode
Off
L RUN On : Normal communication
LED Off : Communication cutoff (time expiration error)
On : Indicates that transmission speed setting or station number
setting is outside the range.
Flicker at fixed intervals
L ERR.
LED Flicker at unfixed intervals : Indicates that you forgot fitting the
Off : Indicates normal communications.
3) 4)
STATION NO.
SELECT
40 20 10 8 4 2 1
SET
CH1 CH2 CH3
V+ I+ V+ I+ COM SLD COM
COM SLD COM V+ I+ V+
6) 7)
10 12 14 16 18
V+ I+ V+ I+ COM
11 13 15 17 19
COM SLD COM V+ I+
Description
: Normal operation
: 24VDC power supply shutoff or watchdog timer
error occurred.
: Indicates that the SELECT/SET switch is in the
SET position.
setting is not any of "user range settings 1 to 3".
0.5s intervals indicate that you attempted to
make offset/gain setting outside the setting
range.
: Indicates that the SELECT/SET switch is in the
SELECT or center position.
: Indicates that transmission speed
setting or station number setting was
changed from that at power-on.
termination resistor or the module or
CC-Link dedicated cable is affected
by noise.
4
5)
B RATE
4 2 1
ON
CH4
AG
I+
(FG1)
Direct-coupled
(Analog I/O section)
20 22 24
SLD COM AG
21 23 25
V+ I+ FG1