Pen Operation And Maintenance - abi IMAGE IQBoardA User Manual

Pen Operation:
Click, Double click:
Do not move pen or finger; press the surface lightly in close quarters (1-2mm).
(Note: Since the whiteboard and the whiteboard pen are delicate electronic products, please
do not hit the surface heavily, o avoid the damage of the whiteboard and the pen point)
Dragging:
Press the surface with the whiteboard pen, and drag it to the appointed position
(the whiteboard pen should not leave the surface midway)
Writing:
Select writing mode and write on the surface . If there is no stroke, please lift the pen up and
wait for the PC to finish processing. (Use the same strength as using a normal fountain pen.)
Orientation:
If space appears between cursor and the point you press, please orientate again. If the
problem cannot be solved, please check if the whiteboard has been installed properly as
per the instructions.
Right Mouse Key:
Press the Right mouse key button on the tool bar, and then wait for 0.5 or 1 second, or go to
the Menu box on the Control Panel, select "mouse right-key" from the menu.
Shift to Left Mouse Key:
If the Right Mouse Key was pressed on the pentray toolbar, the pen will revert to Left Mouse
after one operation. If the Mouse - right Key was pressed in the Menu, go to the Menu box on
the Control Panel, select "mouse left key" from the menu.
Note: Please use 1024x768 image resolution. Close all energy saving modes to avoid
performance delay caused by dormancy. To lengthen life span of the battery, please take it
out if you will not use the electronic pen for a long time.
Maintenance of Pen
1. Take hold of the front point of the pen with left hand, take hold of the rear of the pen with right
hand to open the pen, and slowly pull apart..
2. Remove the rear of the pen to expose the batteries.
3. Take out & replace the batteries. Take care with the positive and negative pole.
Replace the rear cover.
4.
- 27 -