Morso 7440 Instructions For Installation And Use Manual page 28

5. If the condition in step 4 is met, place max. 2 pieces of
wood with a total weight of 1-1.5 kg and a length of 20-
25 cm over the embers in a single layer, with a distance
of approximately 1 cm.
Avoid laying firewood too close to the glass in the stove,
as this can lead to soot staining.
6. Open the air supply to maximum, and close the door.
The fresh wood will be lit within 1-3 minutes.
If it does not light, open the door slightly to allow in en-
ough air to ignite the wood.
Close the door again once the wood has caught.
It is important that the fresh quantity of wood
starts to burn quickly. to ensure the fuel lights
quickly, open the combustion air to max. or leave
the door ajar to allow in the amount of air needed
to light the wood.
If, however, the wood only smoulders, there will
be a strong build-up of smoke, which at worst can
cause an explosive ignition of the flue gases with
the risk of material damage and personal injury.
7. Reduce the amount of combustion air to the desired po-
sition, and the optimal combustion will continue.
Make sure that there is always enough air (oxygen) to
maintain clear, lasting flames when, and after, reducing
the amount of combustion air.
The stoking interval is between 45-75 minutes.
8. Once the fire has been reduced to a thick layer of embers,
a new portion of wood can be added by repeating steps 5
& 7.
28
Important!