Table of Contents
Advertisement
Prestige 681 SDSL Router
7.3
IPX Ethernet Setup
From Menu 3 - Ethernet Setup, enter 3 to go to Menu 3.3 - Novell IPX Ethernet Setup as shown in the
figure below.
Press Space Bar to Toggle.
The following table describes the Novell IPX Ethernet Setup Menu.
Field
Seed Router
Frame Type
IPX Network
#
Press [ENTER] at the message [Press ENTER to Confirm ...] to save your
configuration, or press [Esc] at any time to cancel.
7-4
Menu 3.3 - Novell IPX Ethernet Setup
Seed Router= No
Frame Type 802.2= Yes
IPX Network #= N/A
Frame Type 802.3= No
IPX Network #= N/A
Frame Type Ethernet II= No
IPX Network #= N/A
Frame Type SNAP= No
IPX Network #= N/A
Enter here to CONFIRM or ESC to CANCEL:
Figure 7-3
Menu 3.3 - Novell IPX Ethernet Setup
Table 7-1
Novell IPX Ethernet Setup Fields
Description
Determine if your Prestige 681 is to act as a seed
router.
Enable/Disable the individual frame type.
Remember to enable only the ones that are actually
used on your network.
If your Prestige 681 is a seed router, enter a unique
network number for each frame type enabled.
Options
Yes/No
802.2
802.3
Ethernet II
SNAP
IPX Configuration
Advertisement
Table of Contents
