Test The Operation Of The Cooker Before Leaving; Support Legs - Baumatic BAU95EE Instruction Manual

Test the operation of the cooker before leaving

Note: These burners have no aeration adjustment
Check correct operation of the ignitions system and operation of burners individually and in
combination. Burner flames should be clear blue, with no yellow tipping. If the burners
show any abnormality check that the burners are correctly located. If satisfactory
performance can not be obtained, contact the local gas utility.
Important
Before leaving instruct the owner in the use of the cooker it should be expressly noted that
we cannot accept any liability for direct or indirect damage caused by wrong connection or
improper installation. When being repaired, the appliance must always be disconnected
from the mains supply; if required, notify our customer service

Support legs

The cookers are supplied with four transit supports.(One for each corner).
4 support legs ore supplied separately and are fitted on location to the four corners
of the lower support frame. Each support leg is pushed over the relevant transit
support until flush with the support frame.
Each leg is adjusted by screwing the lower section in or out as required for fitting to a
900mm bench height. For lower bench tops a required.The adjustment
djust the height as
range for the leg is 150-185mm. With the legs adjusted to a height of 180mm the hob is
located 10mm above the horizontal combustable surface, ref. AS5601