Solving Problems; Checking The Printer Status; Checking Messages On The Lcd Screen - Epson XP-432 Series User Manual

User's Guide

Solving Problems

Checking the Printer Status

Checking Messages on the LCD Screen

If an error message is displayed on the LCD screen, follow the on-screen instructions or the solutions below to
solve the problem.
Error Messages
Printer error. Turn power off and on again. For
details, see your documentation.
Operation canceled. Error while saving.
You need to replace the following ink
cartridge(s).
Paper Configuration is disabled. Some features
may not be available. For details, see your
documentation.
The printer's ink pad is nearing the end of its
service life. Please contact Epson Support.
The printer's ink pad is at the end of its service
life. Please contact Epson Support.
Communication error. Connect computer.
Combination of IP address and subnet mask is
invalid. See documentation.
Update the root certificate to use cloud services.
Recovery Mode
* In some print cycles a very small amount of surplus ink may be collected in the ink pad. To prevent ink leakage
from the pad, the printer is designed to stop printing when the pad has reached its limit. Whether and how often
this is required will vary according to the number of pages you print, the type of material that you print and the
Solving Problems
Solutions
If the error message still appears after turning the power off and on
again, contact Epson support.
The memory card may be damaged. Check if your memory card is
available.
To ensure you receive premium print quality and to help protect your
print head, a variable ink safety reserve remains in the cartridge when
your printer indicates it is time to replace the cartridge. Replace the
cartridge when you are prompted to do so.
If Paper Configuration is disabled, you cannot use AirPrint. To use
AirPrint, enable Paper Configuration.
Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part. The message will be displayed
until the ink pad is replaced.
x
Press the button to resume printing.
Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part.
Connect the computer and the printer correctly. If you are connecting
over a network, see the Network Guide. If the error message is still
displayed, make sure that EPSON Scan and Epson Event Manager are
installed on the computer.
See the Network Guide.
Run Web Config, and then update the root certificate.
The printer has started in recovery mode because the firmware update
failed. Follow the steps below to try to update the firmware again.
1. Connect the computer and the printer with a USB cable. (During
recovery mode, you cannot update the firmware over a network
connection.)
2. Visit your local Epson website for further instructions.
103