Epson XP-432 Series User Manual page 21

User's Guide
❏ Pre-punched paper
Note:
❏ Load a single sheet of paper without binding holes at the top or the bottom.
❏ Adjust the print position of your file to avoid printing over the holes.
4. Slide the edge guide to the edge of the paper, and then close the feeder guard.
5. Check the paper size and paper type settings displayed on the control panel. To use the settings, select
u
Confirm using the
u
Change using the
Important:
c
The paper setting screen is not displayed if the paper is not loaded along the right side of the rear paper feed. An
error occurs when you start printing.
Note:
The paper setting screen is not displayed if you have disabled Paper Configuration in the following menus. Go to step 7.
Setup > Printer Setup > Paper Source Settings > Paper Configuration
6. On the paper size setting screen, select the paper size using the
On the paper type setting screen, select the paper type in the same way, and then press the OK button.
Confirm the settings, and then press the OK button.
Note:
You can also display the paper size and paper type settings screen by selecting the following menus.
Setup > Printer Setup > Paper Source Settings > Paper Setup
Loading Paper
d
or button, press the OK button, and then go to step 7. To change the settings, select
d
or button, press the OK button, and then go to the next step.
u d
or button, and then press the OK button.
21