Hangar 9 AT-6 Texan Assembly Manual page 43

Step 2
With the radio system turned on and the throttle stick
centered, slide the EZ connector through the wire and
mount the arm to the servo. With the throttle stick
centered move the throttle arm on your engine to the
center of its throw (1/2 throttle) and tighten the setscrew
on the EZ connector.
Step 3
Using a sharp hobby knife, locate and remove the
covering over the slots for the rudder (right side)
and elevator (left side).
Section 15: Installing the Rudder and Elevator Linkage
Step 3 photo
Step 3 photo
Step 4
To assemble the elevator pushrod, locate one of the wood
dowels. Measure 3" from one end and drill a 5/64" hole.
43