Names Of Each Part On The Control Panel And Remote Control; Preparing And Using The Remote Control - Mitsubishi Electric SE1U User Manual

Names of each part on the control panel and remote control

Control panel
CLASS 1 LED PRODUCT
(7) (8) (9) (10)
FAN TEMP LAMP POWER
SOURCE ON / STANDBY
(2) (1)
ZOOM. +
MENU/ENTER
(6)
VOL. - VOL. +
(5)
KEYSTONE AUTO POSITION
-
ZOOM.
(3) (4)
Name : Main Function
(1) ON/STANDBY button : Turns the power on/off (standby).
(2) SOURCE button : Selects source.
(3) KEYSTONE button : Adjusts keystone (trapezoidal distortion).
(4) AUTO POSITION button : Sets up image and mode.
(5) MENU/ENTER button : Displays menus and makes selections.
(6) Selection buttons : Menu selections and adjustments, etc.
(7) FAN indicator : Displays cooling fan mode.
(8) TEMP indicator : Lights when internal temperature too high.
(9) LAMP indicator : Displays lamp mode.
(10) POWER indicator : Displays whether power is on or off.
(11) MUTE button : Cuts off the picture and sound temporarily.
(12) STILL button : Pauses image.
(13) EXPAND buttons : Enlarge picture size.
(14) EXPAND OFF button : Exiting the operation.
(15) CALL button : Displays the information on the screen.
Note
• For the remainder of this manual, buttons are referred to as follows:
Selection buttons ⇒ ; MENU/ENTER button ⇒
Remote Control
p.20
p.22
p.25
p.24
p.29
p.29
p.23 p.35
p.35
p.21
p.20
p.26
p.26
p.27
p.28
p.28
16

Preparing and using the remote control

I Loading dry-cell batteries
into the remote control
q Remove the battery cover.
w Insert the dry-cell batteries.
Load the batteries making sure that
they are positioned correctly ( + to +,
and - to -). Load the batteries from -
spring side, and make sure to set them
tightly.
Two batteries (R03, SIZE AAA) are
used.
e Replace the battery cover.
Dry-cell batteries
• Before using the batteries, be sure to observe the ABOUT REMOTE BATTERIES
described in previous pages.
• Remove batteries from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace all the batteries with
new ones.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not get wet or place on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If this
happens, point the remote control at the main unit again, and repeat the operation.
I Operating the remote
control
Point the remote control toward the
projector's infrared remote sensor,
and press a button on the remote
control.
• Operating the projector from the front
Approx. 15°
• Operating the projector from the rear
Approx. 15°
17