Using The Remote Control - Mitsubishi Electric WL7050 User Manual

Using the remote control

Operational range of the remote control
Front of projector
About 30° About 30°
fluorescent lamp light.
away from fluorescent lamps. Otherwise, the remote
control may malfunction.
the remote control, the remote control operation may
become unstable.
remote control sensor, the remote control may not work
correctly.
may not work properly from behind the projector.
Reception angle
Vertical directions
Vertical directions (ceiling mount)
Using the wired remote control
Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired
remote control is useful for operating in a distance or outside of the operating area.
REMOTE IN
Rear of projector
About 30° About 30°
Operate the remote control
within a distance of 30 m
(98.4 feet) from the projector,
pointing the light beam at the
remote control photo-sensor
(front or rear) of the projector.
About 30°
About 5°
About 30°
REMOTE IN
REMOTE OUT
You can control the projector by the
remote control signals reflected on the
screen. However, the remote control
distance may be restricted by the
light reflection loss due to the screen
characteristics.
About 20°
About 20°
which is commercially available. However, some cable may
not work correctly.
connected to the REMOTE IN terminal on the other
projector, the two projectors can be controlled together by
using the remote control.
cable, it does not work as a wireless remote control.
period, remove the batteries from it. (Dispose of the
removed batteries according to the cautions on page 6.)
EN-9